1.25G 1550nm SFP+ RJ45 Copper Sfp Fiber Module
1. Circuit ground is internally isolated from chassis ground.
2. Laser output disabled on T DIS >2.0V or open, enabled on T DIS <0.8V.
3. Should be pulled up with 4.7k - 10kohms on host board to a voltage between 2.0V and3.6V.
MOD_DEF(0) pulls line low to indicate module is plugged in.
4. This is an optional input used to control the receiver bandwidth for compatibilitywith multiple data rates (most likely Fiber Channel 1x and 2x Rates). If implemented,the input will be internally pulled down with > 30kΩ resistor. The input states are:
- BT-PON
- Guangdong
- 10000 Unit/Units per Month
- Information
Features:
The optical output can be disabled by a TTL logic high-level input of Tx Disable,and the system also can disable the module via I2C. Tx Fault is provided to indicatethat degradation of the laser. Loss of signal (LOS) output is provided to indicate theloss of an input optical signal of receiver or the link status with partner. The systemcan also get the LOS (or Link)/Disable/Fault information via I2C register access.
Material | Metal |
Color | Silver |
Data Rate | 10Gb/s |
Weight | 20g |
Fiber Interface | LC (SC/ST/FC optional) |
Fiber Type | Simplex, Duplex / Single Mode, Multi mode |
Distance | 300M,10KM, 20KM, 40KM, 80KM, 100KM,... |
Wavelength | 850nm, 1310nm, 1550nm |
Operating Temperature | 0-70℃ |
Ethernet Interface | one UTP RJ45 interface |
Applicable Optical Cable | 10G Ethernet 10G Fiber Channel Data Center Other Optical Links |
Note : This SFP module compatible with CISCO, HUAWEI, JUNIPER, ZTE, D-LINK, HP,... | |
Factory Show
We offer samples free, especially New Products for New Customers and New Region Clients. You can DM our servers online for further information....more
